MAX14763ETA+T Overview
The electronic part can be shipped overseas conveniently because it is packaged in 8-WDFN Exposed Pad. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. Multiplexer and demultiplexer circuits have a number 2:1. The operating temperature is extended to around -40°C~85°C TA. 8 terminations have been made so far. The electronic part provides high-quality output because it has 1 channels. Powered by a 5V voltage supply, the electrical part should be switched on and run. Based on SPDT switching circuits, these analog multiplexers work. Circuits number 1 make up this analogue multiplexer. MAX14763 can be used to search for analog multiplexer variants. It has an internal resistance of 2Ohm. For functions related to 8 pins, please refer to the datasheets. A voltage higher than 5.5V should not normally be supplied to the switches. A cost-effective Single supply type analogue multiplexer. It is recommended to use 3V as the lowest voltage for the electrical part. This multiplexer would work with 4.1mA current. Using a single voltage supply, this switch device consumes 3V~5.5V volts. This product is integrated with an analog integrated circuit (IC) of type SPST. There is a voltage range of 5V operating voltages for the electrical part.
MAX14763ETA+T Features
1 Channels
Switch Circuit: SPDT
4.1mA Supply Current
-3db Bandwidth: 100MHz
MAX14763ETA+T Applications
There are a lot of Maxim Integrated MAX14763ETA+T Analog Switches & Multiplexers ICs applications.
- Cell phones
- Cable Telephony – NIU, Set-Top Box, Home Side Box
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Channelized and Unchannelized DS3 applications
- Data Acquisition Systems
- Power routing
- Microprocessor controlled systems
- Video switching
- Residential Gateways, Home Gateway/Router
- Medical
