DG212DJ+ Overview
As the electronic part is packed in 16-DIP (0.300, 7.62mm), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tube. The multiplexer is located in Through Hole. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -40°C~85°C TA. Total terminations are 16. The electronic part provides high-quality output because it has 1 channels. Powered by a 15V voltage supply, the electrical part should be switched on and run. The electrical component body receives 16 pins. Circuits based on SPST - NO switching are used to construct these analog switch ics. There are 4 circuits in this switch device. Try searching with DG212 to find analog multiplexer variants. An switch multiplexer with 175Ohm internal resistance has a value of 175Ohm. Datasheets for 16 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 18V in normal situations. The analog switch ic is of the Dual supply type and is cost-effective. The lowest voltage the electronic part should receive is 4.5V. An operating current of 20μA would be sufficient for this switch device. When the digital multiplexer is charged above 400μA, damage can occur. Despite this switch device's dual supply capability, its voltage should not exceed 18V. It is recommended that you attach at least 4.5V to your dual power supply. SEPARATE OUTPUT outputs are utilized by this digital multiplexer.
DG212DJ+ Features
1 Channels
Switch Circuit: SPST - NO
20μA Supply Current
DG212DJ+ Applications
There are a lot of Maxim Integrated
DG212DJ+ Analog Switches & Multiplexers ICs applications.
- Imaging
- Ultrasound
- Audio and video switching
- Automatic test equipment
- Precision data acquisition
- Battery-powered systems
- Sample-and-hold systems
- Communication systems
- Data Acquisition Systems
- Relay Replacement
