LT1206CR#TRPBF Overview
The linear amplifier is packaged in a TO-263-8, D2Pak (7 Leads + Tab), TO-263CA case. A Current Feedback-type buffer amplifier is shown here. In the case of Tape & Reel (TR) cases, linear amplifier will be delivered. During the past two weeks, there have been close to 7 terminations. A total of 7 pins are located on this board. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. There are two types of Operational Amplifier op amps in this case, and this device falls into one of them. It is recommended that this electronic component be mounted using the Surface Mount mounting type. It is recommended that this op amp ic be operated at a temperature no higher than 0°C~70°C for optimal performance. A linear amplifier like this has 1 circuits on it. To pack the operational amplifier ics, TAPE AND REEL is adopted as the packing method. To run supply current of buffer amplifier under 20mA.
LT1206CR#TRPBF Features
7 Pins
supply voltage of 5V
LT1206CR#TRPBF Applications
There are a lot of Linear Technology/Analog Devices LT1206CR#TRPBF Instrumentational OP Amps applications.
- Logarithmic operation circuits
- Professional videography
- Active probe
- Video conversion and routing
- Mobile phone
- Laptop
- High/low-pass filter circuit
- Micro signal measurement
- Commercial audio systems
- Radar
