PA13A Overview
Packaged in a SIP case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. There is a growing number of terminations approaching the number of 12. The pins on this board total to 12 in total. I would like to remind you that this buffer op amp should be powered by an 40V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifiers-type of devices. A total of 12 pins are present on the instrumentation amplifier. There is an input offset voltage of 1mV for this buffer op amp. As long as the supply current of the chip does not exceed 25mA, this op amp ic can operate. Keeping the voltage gain at 110dB is the best course of action. As far as the device is concerned, buffer amplifier has 1 channels. For the buffer op amp to operate properly, it must be above the temperature of -25°C degrees Celsius. No temperature greater than 85°C should be used. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 45V volts.
PA13A Features
12 Pins
supply voltage of 40V
110dB voltage gain
PA13A Applications
There are a lot of Cirrus Logic
PA13A Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
