PA04 Overview
Packaged in a DIP case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. There is a growing number of terminations approaching the number of 12. The pins on this board total to 12 in total. I would like to remind you that this buffer op amp should be powered by an 75V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 12 pins are present on the instrumentation amplifier. There is an input offset voltage of 5mV for this buffer op amp. As long as the supply current of the chip does not exceed 70mA, this op amp ic can operate. 102dB should remain the voltage gain. During the manufacturing process, this buffer amplifier is divided into 1 circuits. For the buffer op amp to operate properly, it must be above the temperature of -25°C degrees Celsius. No temperature greater than 85°C should be used. The operating supply voltage of the buffer op amp is rated at 100V. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 200V. A high supply voltage of more than 15V is recommended for the instrumentation amplifier's supply voltage. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 100V volts.
PA04 Features
12 Pins
supply voltage of 75V
102dB voltage gain
PA04 Applications
There are a lot of Cirrus Logic
PA04 Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
