LT6402CUD-20#PBF Overview
A QFN case is used to package the op amp. There are 16 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 6.5mV. An 30mA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain. On this instrumentation amplifier, there are 2 circuits that are connected together. There are 1 channels on the operational amplifiers. In order for op amp to function properly, the temperature should not be lower than 0°C degrees Celsius. Instrumentation amplifier should only be used at temperatures up to 70°C. There are a total of 1 elements in this linear amplifier. The operating supply voltage of the buffer op amp is rated at 5V. I would like to point out that this electrical component is capable of working from a voltage below 5.5V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 4V at all times. 122Ohm should be the range of resistance for the linear amplifier. In total, there are 1 op amps on the device.
LT6402CUD-20#PBF Features
0.827dB voltage gain
Resistance of 122Ohm
LT6402CUD-20#PBF Applications
There are a lot of Analog Devices, Inc.
LT6402CUD-20#PBF Instrumentational OP Amps applications.
- Addition operation circuits
- Subtraction operation circuits
- single/dual op amp sum and difference circuits
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
