LT1812CS5#TR Overview
Packaged in a SOT-23-5 case, the buffer op amp is ready to use. A total of 5 pins are present on the instrumentation amplifier. There is an input offset voltage of 1.5mV for this buffer op amp. As long as the supply current of the chip does not exceed 3mA, this op amp ic can operate. 66.02dB should remain the voltage gain. During the manufacturing process, this buffer amplifier is divided into 1 circuits. As far as the device is concerned, buffer amplifier has 1 channels. For the buffer op amp to operate properly, it must be above the temperature of 0°C degrees Celsius. No temperature greater than 70°C should be used. The linear amplifier consists of 1 different elements in total. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 12.6V. A high supply voltage of more than 2.5V is recommended for the instrumentation amplifier's supply voltage. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 6.3V volts.
LT1812CS5#TR Features
66.02dB voltage gain
LT1812CS5#TR Applications
There are a lot of Analog Devices, Inc.
LT1812CS5#TR Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
