5962-8964201CA Overview
Packaged in a CDIP case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. The op amp is delivered to you in a Bulk case. There is a growing number of terminations approaching the number of 14. The pins on this board total to 14 in total. I would like to remind you that this buffer op amp should be powered by an 15V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 14 pins are present on the instrumentation amplifier. There is an input offset voltage of 1.5mV for this buffer op amp. 92.04dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 1 channels. For the buffer op amp to operate properly, it must be above the temperature of -55°C degrees Celsius. No temperature greater than 125°C should be used. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 15V. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 15V volts.
5962-8964201CA Features
14 Pins
supply voltage of 15V
92.04dB voltage gain
5962-8964201CA Applications
There are a lot of Analog Devices, Inc.
5962-8964201CA Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
