SMP18FS-REEL Overview
It is packaged in an 16-SOIC (0.154, 3.90mm Width)-case that protects the operational amplifiers from damage. This is a Sample and Hold type op amp. A Tape & Reel (TR) case is used to deliver the buffer op amp. During the past two weeks, there have been close to 16 terminations. It consists of a total of 16 pins in total. As a reminder, this buffer op amp should be powered by 5V battery and that the battery should be inserted in the amplifier. The op amp ic has an array of 16 pins on it. Op amp ic rates 2.5mV for input offset voltage. It is recommended that this electronic component be mounted using the Surface Mount mounting type. It is recommended that this op amp ic be operated at a temperature no higher than -40°C~85°C for optimal performance. An 6mA volt supply current is needed for this linear amplifier to operate. There are 8 circuits on this op amp.
SMP18FS-REEL Features
16 Pins
supply voltage of 5V
SMP18FS-REEL Applications
There are a lot of Analog Devices Inc. SMP18FS-REEL Instrumentational OP Amps applications.
- Television
- RF cable systems
- Video amplifiers
- Fission chambers
- Micro signal measurement
- High/low-pass filter circuit
- Switching amplifier
- Communication device
- Ultrasound transducers
- Navigation
