ADTL084ARZ-REEL Overview
It is packaged in an 14-SOIC (0.154, 3.90mm Width)-case that protects the operational amplifiers from damage. A J-FET-type buffer amplifier is shown here. It comes in a Tape & Reel (TR) case, which protects instrumentation amplifier from damage during delivery. It is estimated that there will be 14 terminations in the next few months. A total of 14 pins are located on this board. As a reminder, this buffer op amp should be powered by 15V battery and that the battery should be inserted in the amplifier. To be specific, this instrumentation amplifier is a type of Operational Amplifier. 14 pins are located on the operational amplifiers. With regards to the offset voltage of the input, buffer amplifier is rated at 5.5mV. It is recommended that this electronic component be mounted using the Surface Mount mounting type. The buffer amplifier functions well at -40°C~125°C as far as operating temperature is concerned. You can run this op amp ic on 4.8mA . 106.02dB should be the voltage gain. Instrumentation amplifier has 4 channels on it. This linear amplifier pack is based on the TAPE AND REEL axis. There is an 1.2mA quiescent current in linear amplifier.
ADTL084ARZ-REEL Features
14 Pins
supply voltage of 15V
106.02dB voltage gain
ADTL084ARZ-REEL Applications
There are a lot of Analog Devices Inc. ADTL084ARZ-REEL Instrumentational OP Amps applications.
- Laptop
- Cinema or auditorium audio system
- Communication device
- Multimedia playback equipment
- Hand-held batteries
- earphone
- Polarized electrodes
- Biopotential
- Vehicle electronics
- Power transmission
