ADG836YRM Overview
Shipping overseas is convenient due to the electrical component's packing in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width). High reliability is provided by advanced packaging method Tube. Mounted in Surface Mount is this multiplexer. 2:1 is the ratio of multiplexer to demultiplexer circuits. Extended operating temperature around -40°C~125°C TA. The total number of terminations is 10. A 2 channel electronic part produces high-quality output. It is safe to turn on and run the electronic component with a 1.8V voltage supply. It is part of the design of the 10 series that this electronic component is included. Multiplexers built on a SPDT switching circuit are built. Look for analog switch ic variants by searching with ADG836. Analog switches have 650mOhm internal resistance. To find out what the 10 pins do, please refer to the datasheets. This switch device is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 3.6V. A cost-effective Single supply type analogue multiplexer. 1.65V is the lowest voltage the electrical component should receive. Analogue multiplexers require a 1.65V~3.6V voltage to drain from a single voltage supply. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. A 57MHz-bandwidth can be used for data transfer. An output of 4 is provided by the digital multiplexer.
ADG836YRM Features
2 Channels
Switch Circuit: SPDT
Bandwidth: 57MHz
ADG836YRM Applications
There are a lot of Analog Devices Inc. ADG836YRM Analog Switches & Multiplexers ICs applications.
- PBX interfaces
- Low-Voltage
- Ultrasound
- Communication systems
- Cable Modem
- Signal routing between systems
- Battery-powered systems
- PDAs
- Mechanical reed relay replacement
- T1/E1 Terminals
