ADG801BRM-REEL7 Overview
The electronic part can be shipped overseas conveniently because it is packaged in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. There is an analog multiplexer mounted in position Surface Mount. There is 1:1 ratio between the number of multiplexers and demultiplexers. Around -40°C~125°C TA is the extended operating temperature. In total, there are 8 terminations. This electronic part offers high-quality output due to its 1 channels. In the case of a voltage supply of 3V volts, the electrical part can be powered up and run. There are 8 pins injected into the electronic part body. The analog switch ics are built using SPST - NO switching circuits. Search with ADG801 if you are looking for analog multiplexer variants. It has an internal resistance of 300mOhm. The functions of 8 pins can be found in the datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. In normalcircumstances, users should not exceed 5.5V volts for the multiplexer. Single supply type digital switch with a low cost. 1.8V is the lowest voltage that should be fed to the electronic electronic part. A voltage of 1.8V~5.5V is required to drain this analog switch from a single voltage supply. A digital multiplexer may suffer damage if voltage is applied above 1μA.
ADG801BRM-REEL7 Features
1 Channels
Switch Circuit: SPST - NO
-3db Bandwidth: 12MHz
ADG801BRM-REEL7 Applications
There are a lot of Analog Devices Inc.
ADG801BRM-REEL7 Analog Switches & Multiplexers ICs applications.
- Isolation
- Medical
- Imaging
- Ultrasound
- Audio and video switching
- Automatic test equipment
- Precision data acquisition
- Battery-powered systems
- Sample-and-hold systems
- Communication systems
