ADG702BRM Overview
The electrical component comes in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) packaging, which makes it convenient to ship overseas. This packaging method provides high reliability because it uses advanced packaging techniques. Mounted in Surface Mount is this multiplexer. There is 1:1 ratio between the number of multiplexers and demultiplexers. Extended operating temperature around -40°C~85°C TA. Totally, there are 8 terminations. A high-quality output is provided by the electrical component's 1 channels. In the case of a voltage supply of 3V volts, the electrical part can be powered up and run. 8 pins are injected to the electronic part body. Multiplexers built on a SPST - NC switching circuit are built. Try searching for the analog switch ic with ADG702 if you are looking for variants. The internal resistance of this digital multiplexer is 3Ohm. The functions of 8 pins can be found in the datasheets. It is a typical Multiplexer or Switches analog multiplexer. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. The lowest voltage fed to the electronic component should be 1.8V. A voltage of 1.8V~5V is required to drain this analog switch from a single voltage supply. Putting voltage greater than 1μA on the multiplexer may cause damage.
ADG702BRM Features
1 Channels
Switch Circuit: SPST - NC
-3db Bandwidth: 200MHz
ADG702BRM Applications
There are a lot of Analog Devices Inc. ADG702BRM Analog Switches & Multiplexers ICs applications.
- Transmit
- ADCs such as AD7840/8, AD7870/1/2/4/5/6/8
- High reliability control systems
- Isolation
- Remote Powered Equipment
- Low-Voltage
- PDH Multiplexers
- Battery Powered Instruments
- Modems
- PBXs
