ADG701LBRJZ-REEL Overview
Packed in SC-74A, SOT-753, the electronic component is convenient for shipping overseas. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). Mounted in Surface Mount is this multiplexer. Multiplexers and demultiplexers have a ratio of 1:1. Operation at a temperature around -40°C~85°C TA. In total, there have been 5 terminations. By its 1 channels, the electronic component provides high-quality output. With a 3V voltage supply, the electrical component should be turned on and run. There are 5 pins injected into the electronic part body. The analog switch ics are built using SPST - NO switching circuits. Try searching with ADG701 if you're looking for variants. A 3Ohm internal resistance characterizes this multiplexer. You can find the functions of the 5 pins in the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 5.5V to the switch device in normal circumstances. In order for the electronic part to function properly, the lowest voltage should be 1.8V. This analogue multiplexer requires a voltage of 1.8V~5V when it drains from a single voltage supply. Put voltage above 1μA on the multiplexer to cause damage. The 1 inputs need to be operated in order to work.
ADG701LBRJZ-REEL Features
1 Channels
Switch Circuit: SPST - NO
-3db Bandwidth: 200MHz
ADG701LBRJZ-REEL Applications
There are a lot of Analog Devices Inc. ADG701LBRJZ-REEL Analog Switches & Multiplexers ICs applications.
- T1/E1 Terminals
- Communication systems
- FTTH
- Automotive applications
- Sample-and-hold systems
- Mechanical reed relay replacement
- Voice over IP/DSL – Integrated Access Devices, Smart
- Cable Modem
- Signal routing between systems
- Channelized and Unchannelized DS3 applications
