ADG5412FTRUZ-EP-R7 Overview
Presented in 16-TSSOP (0.173, 4.40mm Width), this electrical component is convenient for overseas shipping. This packaging method provides high reliability because it uses advanced packaging techniques. There is an analog multiplexer mounted in position Surface Mount. There is 1:1 ratio between the number of multiplexers and demultiplexers. Operational temperature extended around -40°C~125°C TA. In total, there are 16 terminations. The electronic part provides high-quality output because it has 1 channels. If the voltage supply is 15V volts, the electrical component should be turned on and run. A total of 16 pins are injected into the body of the electronic part. Circuits based on SPST - NO switching are used to construct these analog switch ics. Circuits number 4 make up this analogue multiplexer. If you are looking for variants of the digital switch, trying search with ADG5412. As far as internal resistance is concerned, it has 11.5Ohm. To find out what the 16 pins do, please refer to the datasheets. normally, users should not supply switches with voltages higher than 44V. A low voltage of 8V should be applied to the electronic component. Despite this switch's dual supply capability, its voltage should not exceed 22V. If you are using dual power supplies, you should attach at least 5V. There are various bandwidths available for data transfer.
ADG5412FTRUZ-EP-R7 Features
1 Channels
Switch Circuit: SPST - NO
-3db Bandwidth: 270MHz
Bandwidth: 160MHz
ADG5412FTRUZ-EP-R7 Applications
There are a lot of Analog Devices Inc. ADG5412FTRUZ-EP-R7 Analog Switches & Multiplexers ICs applications.
- Audio signal routing
- 65 V DACs
- Automatic test equipment
- Mechanical reed relay replacement
- Channel Banks
- Channelized and Unchannelized DS3 applications
- ADCs such as AD7840/8, AD7870/1/2/4/5/6/8
- Precision instrumentation
- Industrial control systems
- DSLAMs
