ADG513BNZ Overview
Shipping overseas is convenient with the electronic component packed in 16-DIP (0.300, 7.62mm). The advanced packaging method Tube provides high reliability. This analog switch is mounted in Through Hole. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature around -40°C~85°C TA extended. In total, there have been 16 terminations. High-quality output is provided by the electronic component's 4 channels. When a voltage supply of 5V is used, the electronic component should be turned on and run. An electrical component of this type can be found in the 16 series. Multiplexers built on a SPST - NO/NC switching circuit are built. Try searching for the analog switch ic with ADG513 if you are looking for variants. An switch multiplexer with 30Ohm internal resistance has a value of 30Ohm. For details about the functions of 16 pins, please refer to the datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 5.5V in normal situations. A analog switch ic that has a cost-effective Dual, Single supply type. It is recommended that the electrical component receives a voltage of 4.5V. A voltage higher than 1μA may cause damage to the switch multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 5.5VA dual power supply should have at least 4.5V voltage attached. This analog switch ic utilizes SEPARATE OUTPUT output.
ADG513BNZ Features
4 Channels
Switch Circuit: SPST - NO/NC
ADG513BNZ Applications
There are a lot of Analog Devices Inc. ADG513BNZ Analog Switches & Multiplexers ICs applications.
- Communication systems
- Optical Applications
- SONET
- PDAs
- Cell phones
- Medical Instrumentation
- Communications systems
- Remote Powered Equipment
- Cellular phones
- Intelligent PBX
