ADG506AKN Overview
The electronic part can be shipped overseas conveniently because it is packaged in 28-DIP (0.600, 15.24mm). This high-reliability packaging method uses advanced packaging methods Tube. The multiplexer is located in Through Hole. Multiplexers and demultiplexers have a number of circuits 16:1. Temperatures around -40°C~85°C TA are extended for operation. Total terminations are 28. High-quality output is provided by the electronic component's 16 channels. An 15V voltage supply should allow the electrical part to be turned on and run. An electrical component like this is included in the 28 series. The multiplexer consists of 1 circuits. Use ADG506 to search for variants of the digital switches. There is 300Ohm internal resistance in this digital multiplexer. For details about the functions of 28 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. Users shouldn't supply more than 16.5V voltage to the switch device. It is recommended to use 10.8V as the lowest voltage for the electrical part. In order to operate this switch device, it would need a current of 600μA. Despite this switch's dual supply capability, its voltage should not exceed 16.5V. You should attach at least 10.8V voltage if you are using dual power supply. A SINGLE-ENDED MULTIPLEXER analog IC is integrated into the board.
ADG506AKN Features
16 Channels
600μA Supply Current
ADG506AKN Applications
There are a lot of Analog Devices Inc. ADG506AKN Analog Switches & Multiplexers ICs applications.
- SONET
- Public switching systems
- CSU
- E1 Network Equipment
- Communications systems
- Modems
- Precision data acquisition
- PCMCIA cards
- USB 1.1 signal switching circuits
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
