ADG1201BRJZ-REEL7 Overview
The electronic part can be shipped overseas conveniently because it is packaged in SOT-23-6. High reliability is ensured by the advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 1:1 is the ratio of multiplexer to demultiplexer circuits. Extended operating temperature around -40°C~125°C TA. In total, there have been 6 terminations. 6 pins are injected to the electronic part body. On the other hand, analog switches can be constructed using SPST - NO switching circuits. Look for analog switch ic variants by searching with ADG1201. In this multiplexer, the internal resistance is 200Ohm. The functions of 6 pins can be found in the datasheets. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 16.5V should not normally be supplied to the switches. Analogue multiplexer with a Dual, Single supply type that is cost-effective. The lowest voltage the electronic part should receive is 5V. An operating current of 60μA would be sufficient for this switch device. A digital multiplexer may suffer damage if voltage is applied above 95μA. Dual supply volatge is feasible for this multiplexer. But it should not go beyond 16.5V. If you are using a dual power supply, you should attach at least 5V. Operating voltages of 12V are compatible with the electrical part. There are 1 inputs to be operated.
ADG1201BRJZ-REEL7 Features
Switch Circuit: SPST - NO
60μA Supply Current
-3db Bandwidth: 660MHz
ADG1201BRJZ-REEL7 Applications
There are a lot of Analog Devices Inc. ADG1201BRJZ-REEL7 Analog Switches & Multiplexers ICs applications.
- HDTV
- Digital Cross-Connects
- Avionics
- Low-Voltage
- Access Concentrators
- Modems
- PBX interfaces
- High reliability control systems
- Residential Gateways, Home Gateway/Router
- Power routing
