5962-8771601EA Overview
Packaged in a Q case, the buffer op amp is ready to use. There is a growing number of terminations approaching the number of 16. The pins on this board total to 16 in total. I would like to remind you that this buffer op amp should be powered by an 15V battery. I would like to specify that this buffer amplifier belongs to the Multiplexer or Switches-type of devices. A total of 16 pins are present on the instrumentation amplifier. As long as the supply current of the chip does not exceed 12mA, this op amp ic can operate. As far as the device is concerned, buffer amplifier has 8 channels. For the buffer op amp to operate properly, it must be above the temperature of -55°C degrees Celsius. No temperature greater than 125°C should be used. The operating supply voltage of the buffer op amp is rated at 15V. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 18V volts. Instrumentation amplifier resistance should stay within the range of 500Ohm. It should be noted that the other type of analog integrated circuit used in this instrumentation amplifier is known as the SINGLE-ENDED MULTIPLEXER. It is important to note that this buffer op amp also has the following extra benefit: OVERVOLTAGE PROTECTION.
5962-8771601EA Features
16 Pins
supply voltage of 15V
Resistance of 500Ohm
5962-8771601EA Applications
There are a lot of Analog Devices Inc.
5962-8771601EA Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
