ALD2702ASAL Overview
Packaged in a 8-SOIC (0.154, 3.90mm Width) case, the buffer op amp is ready to use. An op amp ic of the General Purpose type. The op amp is delivered to you in a Tube case. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 1mV for this buffer op amp. The mounting type that is recommended for this electrical part is Surface Mount. In relation to the operating temperature of this buffer op amp, it works well at an average of 0°C~70°C . As long as the supply current of the chip does not exceed 2mA, this op amp ic can operate. 107.96dB should remain the voltage gain. During the manufacturing process, this buffer amplifier is divided into 2 circuits. As far as the device is concerned, buffer amplifier has 2 channels. One of the many advantages that this linear amplifier has, among many other things, is the fact that it outputs Push-Pull, Rail-to-Rail signals. For the buffer op amp to operate properly, it must be above the temperature of 0°C degrees Celsius. No temperature greater than 70°C should be used. The operating supply voltage of the buffer op amp is rated at 5V. As a result, it is recommended that a power supply of 2mA be used with this electronic part. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 6V volts.
ALD2702ASAL Features
107.96dB voltage gain
Output Type: Push-Pull, Rail-to-Rail
ALD2702ASAL Applications
There are a lot of Advanced Linear Devices Inc.
ALD2702ASAL Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
