0 votes
by (120 points)
How add DHT h to Arduino?

1 Answer

0 votes
by (1.6k points)
The DHT11 is a basic, ultra low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple to use, but requires careful timing to grab data.May 15, 2020');})();(function(){window.jsl.dh('_7rKHYPn8GInb-gSCvJMo44','
');})();(function(){window.jsl.dh('11','
The DHT11 calculates relative humidity by measuring the electrical resistance between two electrodes. The humidity sensing component of the DHT11 is a moisture holding substrate with the electrodes applied to the surface. ... The change in resistance between the two electrodes is proportional to the relative humidity.

Related questions

0 votes
1 answer
0 votes
0 answers
0 votes
1 answer
0 votes
1 answer
0 votes
1 answer
0 votes
1 answer
asked Jul 24, 2021 by esp8266esp (120 points)
0 votes
1 answer
0 votes
1 answer
0 votes
1 answer
...