DF14-2628SCFA

B241

DF14 Series

●

1.25mm Pitch Super Low profile Crimping Connector

1. Recommended Temperature Profile (SMT)

Note 1.Up  to  2  cycles  of  Reflow  soldering  are  possible  under  the  same  conditions,  provided

that  there is a return to normal temperature between the first and second cycle.

Note 2.The  temperature  profile  indicates  the  board  surface  temperature  at  the  point  of

contacts with the connector terminals.

2. Recommended Manual Soldering Condition (SMT)

Manual soldering: 290ç for 2 seconds

3. Recommended Screen Thickness (SMT)

0.15 to 0.2mm

4. Board Sled (SMT)

Max 0.03mm at the connector center area, based on both connector edges

5. Cleaning Condition

Refer to Nylon Connector Use Hand book.

6. Connection Condition

Refer to Nylon Connector Use Hand book.

■Be  careful  to  carry  out  the  crimping  operation  according  to  the  "Crimping  Condition  Sheet"

and "Crimping Quality Reference", because the crimping contact style is too small.

7. Precautions

Refer to Nylon Connector Use Hand book.

8. Cautions

■Be  careful  for  an  excessive  scoop  insertion/extraction,  which  will  cause  damage  to  the

product.

B

Precautions

B

Precautions

Diagonal

Parallel

Diagonal

Parallel

Diagonal

Parallel

Diagonal

Parallel

100ç

150ç

200ç

250ç

Max. 240

220

Time

Temperature

10s max.

60 to 120s

Preheating

60s max.

Soldering

IR reflow condition

Preheating area 150ç for 60 to 120 seconds

Soldering area 250 for 10 seconds max.

220ç min. 60 seconds max.

Precautions at Time of Insertion

Precautions at Time of Disconnection

Handling

Method: Lightly  grasping  the  base  of  the  cable,  press  the

connector with your finger and insert it.

Handling

Method: Grasp  the  cable  so  that  the  entire  cable  is  pulled

evenly and pull it out.

Insertion Angle

[Caution] Do  not  insert  at  an  angle  of  30°  or  greater.  Doing  so

will cause contact deformation or case damage.

Method: Insert with the connector parallel.

Angle of Removal

[Caution] Do not remove at an angle of 30° or greater. Doing so

will cause contact deformation or case damage.

Method: Remove with the connector parallel.

The product  information in this catalog is for reference only. Please request the  Engineering Drawing for the most current and accurate design  information.

All non-RoHS products  have been discontinued, or will be discontinued soon. Please check the  products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your  Hirose sales representative.

DF14-2628SCFA Information:
Part No.
DF14-2628SCFA

RFQ

Description
CONN TERM 26-28AWG CRIMP GOLD
File Size
281286 bytes
Page Size
609 x 793 pts
All Pages
8
Manufacturer
Hirose Electric Co., Ltd.
Homepage
http://www.hirose.com/
Logo
DF14-2628SCFA Datasheet Related Products: